Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 68)

Installing Your
Programmable Controller
Chapter 4
4-29
4. Replace the battery cover.
5. Tighten the screw.
How to Dispose of the Battery
Batteries should be collected for disposal in a manner to prevent short
circuiting, compacting, or destruction of case integrity and hermetic seal.
ATTENTION: Do not incinerate or dispose of lithium batteries
in general trash collection. Explosion or violent rupture is
possible.
For disposal, batteries must be packaged and shipped, in accordance with
transportation regulations, to a proper disposal site. The U.S. Department
of Transportation authorizes shipment of “lithium batteries for disposal” by
motor vehicle only in regulation 173.1015 of CFR49 (effective Jan. 5,
1983). For additional detailed information, contact:
U. S. Department of Transportation
Research and Special Programs Administration
400 Seventh Street, S.W.
Washington, D.C. 20590
Although the United States Environmental Protection Agency at this time
has no regulations specific to lithium batteries, the material contained in
the battery may be considered toxic, reactive, or corrosive. The person
disposing of the material is responsible for any hazard created in doing so.
State and local regulations may exist regarding the disposal of
these materials.
If you have a processor with a power supply, start at step 1. If you have a
processor without a power supply, turn off power to the chassis and start at
step 5.
1. Move the POWER switch to the off position.
2. Turn off the incoming power source to the processor and chassis
3. Unplug the power cable
4. Lift the latch of the I/O chassis that holds your processor.
5. Slide the processor out of the I/O chassis.
Step 7 - Installing the
EEPROM Memory Module