Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 363)

ESC
40
ESC
MR
Report Generation
Chapter 23
23-12
The word SEARCH appears in the lower left hand corner of the screen.
The words AUTOMATIC REPORT GENERATION appear across the top
of the screen and appear in the lower left hand corner of the screen. The
word SEARCH changes to SEARCH 40.
CHANNEL C: 9600 BAUD; INPUT = ON; HANDSHAKE = ON
RECORD
If your processor is in Program mode, the following message appears
underneath the words AUTOMATIC REPORT GENERATION:
PROCESSOR NOT IN RUN OR TEST MODE.
Change modes and continue.
Press [Cancel Command] to exit report generation.
You can enter automatic report generation by another method if you have
the Alphanumeric Key top overlay (cat. no. 1770-KAA) on the keytop and
the processor is in the Run or Run/Program mode. The processor must
also be in report generation. Perform the following steps:
MR appears on the screen.
The words AUTOMATIC REPORT GENERATION appear across the top
of the screen.
If your processor is in the Program mode, the following message appears
underneath the words AUTOMATIC REPORT GENERATION:
PROCESSOR NOT IN RUN OR TEST MODE.
Change modes and continue.
Press [Esc] [Esc] to exit Automatic report generation