Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 81)

Installing Your
Programmable Controller
Chapter 4
4-42
Setting the Input Voltage Selector Switch
The processors can operate on 120 or 220 V ac. Select the required
operating voltage by setting the Input Voltage Selector Switch at the rear
of the processor (Figure 4.24). The processor is shipped set for
120V operation.
Figure 4.24
Location of the Input Voltage Selector Switch
20216
input voltage
selector switch
To connect your 1770-T3 terminal to the processor refer to Figure 4.25.
Figure 4.25
The Connections between an Industrial Terminal and a Processor
Channel A
Industrial Terminal
(rear view)
Program Panel
Interconnect Cable
Interface
MiniĆPLCĆ2/02, Ć2/16, Ć2/17
PLCĆ2 Family
10249
cat. no. 1772ĆTC
10 ft (3.05 cm)
Step 12 - Connecting the
Industrial Terminal