Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 61)

Installing Your
Programmable Controller
Chapter 4
4-22
Figure 4.13
Locating Switch Group Assembly on the Backplane of an I/O Chassis
Switch
Group
Assembly
Table 4.C and Table 4.D explain how each switch is used by the processor.
Switches 2 and 3 are not used. Use a ball-point pen to set each switch. Do
not use a pencil because the tip can break off and jam the switch.
Step 3 - Setting the
Switches within the Switch
Group Assembly