Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 356)

MS,n
RETURN
ESC ESC
Report Generation
Chapter 23
23-5
Table 23.C
Address Delimiters
Delimiter Format Explanation Message Report Format
*XXX* Enter 3Ćdigit word address between delimiters. Displays the 3Ćdigit BCD value at assigned
word address.
*XXX1*
or
*XXX0*
Enter 3Ćdigit word address and a 1" for upper byte or a
0" for lower byte between delimiters.
Displays the 3Ćdigit octal value at assigned
byte address.
*XXXXX* Enter 5Ćdigit bit address between delimiters. Displays the On or Off status of the assigned bit
address.
#XXX# Enter 3, 4, or 5Ćdigit word address between delimiters. Displays the 3Ćdigit BCD value at assigned
word address.
!XXX! Enter 3, 4, or 5Ćdigit word address between delimiters. Displays the 4Ćdigit hex value at address.
&XXX1&
&XXX0&
Enter 3, 4, or 5 digit word address and a 1"for upper
byte or a 0" for lower byte between delimiters.
Displays the 3Ćdigit octal value at the assigned
byte address.
^XXXXX^ Enter 5, 6, or 7Ćdigit bit address between delimiters. Displays the On or Off status of the assigned bit
address.
The desired delimiter is entered before and after the bit, byte, or word
address. The delimiter tells the industrial terminal to print the current
status or value of the bit, byte, or word at the address. You can enter as
many consecutive addresses as needed by sharing the same delimiter, such
as *XXX*XXX*XXX*.
As an example, suppose you want to report the on/off condition of a device
SR6, during each cycle of machine operation. The delimiters denote the
output address 013/05, and the cycle counter accumulated value (stored at
030). The desired message, “SR6 is (on or off) in cycle (xxx)”, is entered
into memory with the following keystrokes:
You must be in report generation.
MS,n appears on the screen.
n = message number
READY FOR INPUT appears on the screen.
SR6 [space] IS [space] *01305* [space] IN [space] CYCLE [space] #030#