Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 31)

Hardware Features
Chapter 3
3-5
Figure 3.2
With a Power Supply
PROC
F
A
U
L
T
R
U
N
BATT
INTFC
BATTERY
INSTALLED
MINI-PLC-2/17
RUN
R/P
MEM
STORE
PROC indicator lights green for normal operation and
red for a processor fault. Off indicates that you are in
Program Mode or a possible runĆtime error. You
reset this LED by cycling power.
BATT (Red) lights when battery should be replaced.
Key Switch selects one of four positions:
PROG: Program
R/P: Run/Program
RUN: Run
MEM STORE: Transfer program to MEM STORE backup EEPROM
Battery backup helps protect stored memory.
Interface Port allows you to connect
information sources such as a 1770ĆT3
terminal, handĆheld terminal. Data Highway
or Report Generation module.
10295–I
W/POWER SUPPLY
POWER
ON
OFF
1A 250V
SLOW BLOW
120/220
V.A.C.
L1
L2/N
GND
P
R
O
G
P/S
ACTIVE
P
/
S
P
R
L
Line Voltage Selector Switch (located in rear)
Green LED lights for normal
power supply operation.
Port allows you to parallel the processor
power supply with another power supply
in the I/O chassis.
Toggle switch controls the
processor power supply.
Fuse holder for a 1A, 250V,
slowĆblow power supply fuse.
120/220VAC terminals:
L1 - Line
L2/N - Line (220V)/Neutral (120V)
GND - Ground Bus
Mode Select Key Switch
You can place the processor in any one of three modes of operation or
program the EEPROM with the key switch located on the front of
the processor.