Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 370)

Report Generation
Chapter 23
23-19
Table 23.E
Industrial Terminal Control Codes
Control Code
Key Sequence
Function
[CTRL][P]
[Column #][;]
[Line #][A]
Positions the cursor at the specified column and line number
[CTRL][P][A] positions the cursor at the top left corner of the screen.
[CTRL][P][F] Moves the cursor one space to the right.
[CTRL][P][U] Moves the cursor one line up in the same column.
[CTRL][P][5][C] Turns cursor on.
[CTRL][P][4][C] Turns cursor off.
[CTRL][P][5][G] Turns on graphics capability.
[CTRL][P][4][G] Turns off graphics capability.
[CTRL][P][5][P] Turns Channel C outputs on.
[CTRL][P][4][P] Turns Channel C outputs off.
[CTRL][I] Horizontal tab that moves the cursor to the next preset 8th position.
[CTRL][K] Clears the screen from cursor position to end of screen and moves the
cursor to the top left corner of the screen.
Key Sequence Attribute
1
[CTRL][P][0][T] Attribute 0 = Normal Intensity
[CTRL][P][1][T] Attribute 1 = Underline
[CTRL][P][2][T] Attribute 2 = Intensify
[CTRL][P][3][T] Attribute 3 = Blinking
[CTRL][P][4][T] Attribute 4 = Reverse Video
Any three attributes can be used at one time using the following key sequence:
[CTRL][P][Attribute #][;][Attribute #][;][Attribute #][T]
1
In addition, standard ASCII control codes can be used with the industrial
terminal (Table 23.F). These codes, although not displayed, can be
interpreted and acted on by a peripheral device connected to channel C.