Rockwell Automation 1772-L8_LW_LWP_LX_LXP,D17726.5.8 User Manual - Manual (Page 473)

Quick Reference
Appendix E
E-29
Address Delimiters
Delimiter Format Explanation Message Report Format
*XXX* Enter 3Ćdigit word address between delimiters. Displays the 3Ćdigit BCD value at assigned
word address.
*XXX1*
or
*XXX0*
Enter 3Ćdigit word address and a 1" for upper byte or a
0" for lower byte between delimiters.
Displays the 3Ćdigit octal value at assigned
byte address.
*XXXXX* Enter 5Ćdigit bit address between delimiters. Displays the On or Off status of the assigned bit
address.
#XXX# Enter 3, 4, or 5Ćdigit word address between delimiters. Displays the 3Ćdigit BCD value at assigned
word address.
!XXX! Enter 3, 4, or 5Ćdigit word address between delimiters. Displays the 4Ćdigit hex value at address.
&XXX1&
&XXX0&
Enter 3, 4, or 5 digit word address and a 1"for upper
byte or a 0" for lower byte between delimiters.
Displays the 3Ćdigit octal value at the assigned
byte address.
XXXXX Enter 5, 6, or 7Ćdigit bit address between delimiters. Displays the On or Off status of the assigned bit
address.
Report Generation Commands
Command Key Sequence Description
Enter report generation
function
[RECORD][DISPLAY]
Set baud rate
(Message Code Keys)
Puts industrial terminal into report
generation function.
Same (entered from a peripheral device).
Message store [M][S][,]
(Message Number)
[RETURN]
Stores message in processor memory. Use [ESC]
to end message.
Message print [M][P][,]
(Message Number)
[RETURN]
Prints message exactly as entered.
Message report [M][R][,]
(Message Number)
[RETURN]
Prints message with current data table values or
bit status.
Message delete [M][D][,]
(Message Number)
[RETURN]
Removes message from processor memory.
Message index [M][I][RETURN] Lists messages used and the number of words in
each message.
Automatic report
generation.
[SEARCH][4][0]
[M][R][RETURN]
Allows messages to be printed through
program control.
Exit automatic report
generation
[ESC]
[CANCEL COMMAND] 1
Terminates automatic report generation.
Exit report [ESC]
[CANCEL COMMAND] 1
Returns to ladder diagram display.
Terminates Report Generation Function.
[CANCEL COMMAND] can only be used if the function was entered by a command from a peripheral device.
1
Report Generation