Rockwell Automation 1797-OE8H FLEX Ex HART Analog Modules User Manual - Manual (Page 94)

Publication 1797-6.5.3 - March 2006
5-18 Calibrate Your Module
Table 5.13 1797-OE8H Interpretation of Calibration Data Structure Content During Read Access (Pending Status)
Command Byte Item Byte Data1 Byte Data2 Byte
Status (Binary) Command Bits 0…5 (Decimal)
10 Pending 1 Calibration command number 1 is in interpretation
now Channel-Mask 0 0
2 Calibration command number 2 is in interpretation
now
3 The written min scale value of Current is in
interpretation now Value
low-byte Value
high-byte
4 The written min scale value of Voltage is in
interpretation now
5 The written max scale value of Current is in
interpretation now
6 The written max scale value of Voltage is in
interpretation now
7 Reserved (1) Reserved (1) Reserved (1) Reserved (1)
8 All calibration values are set to default now 0 0 0
9 The specified calibration value is set to default
now Value-identifier
10 Reserved (2) Reserved (2) Reserved (2) Reserved (2)
11
Reserved (2)
12 Reserved (2)
13 Reserved (2)
14 The calibration data is saved to EEPROM right now 0 0 0
15…61 The unknown command is trying to be interpreted x 2 x 2 x 2
62 The specified setup-value is written now Setup
value-identifier Value
low-byte Value
high-byte
63 The setup data is saved to EEPROM right now 0 0 0
(1) Do not use. Designated for future use.
(2) Reserved. Used during manufacture of the product. Do not use.