Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 101)

Publication IASIMP-QS010B-EN-P - October 2009 101
Add a PanelView Plus 600 Terminal Chapter 6
Assign an IP Address to the Terminal
Required for all controllers
1. On the PanelView Plus terminal’s main page,
press Terminal Settings [F4].
2. Navigate to:
Networks and
Communications
> Network
Connection >
Network Adaptors >
Built-in Ethernet Controller.
3. Press IP Address [F2].
4. Press IP Address [F1] and enter
an IP address.
For more information about IP
addresses, see
Chapter 2 , on
page 97 .
5. Record the IP address on the
Network Worksheet and press
Enter.
6. Select Subnet Mask [F2].
7. Enter the subnet mask you wrote
on the Network Worksheet
located inside the back cover.
8. Press Enter.
9. Press OK [F7], then Press OK [F7] again.
10. Press Close [F8] until you return to the
Terminal Settings screen.