Assemble the compactlogix hardware, Before you begin, What you need – Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual User Manual
Page 23: Chapter 1, Assemble the compactlogix, Hardware, Proceed to, Before you begin what you need
23
Publication IASIMP-QS010B-EN-P - October 2009
23
Chapter
1
Assemble the CompactLogix Hardware
In this chapter, you install your CompactLogix hardware packaged controller.
Before You Begin
Determine which of these networks and appropriate hardware to use:
•
For the EtherNet/IP network (option 1), use either the 1769-L23E-QB1B or
1769-L23E-QBFC1B controller.
•
For a serial connection (option 2), use the 1769-L23-QBFC1B controller.
What You Need
•
CompactLogix packaged controller: 1769-L23E-QB1B, 1769-L23E-QBFC1B, or
1769-L23-QBFC1B.
•
CompactLogix controller battery: 1769-BA (included with your controller).
•
Power supply: This quick start uses the 1606-XLS80E supply, but any DC power supply
that meets the requirements for the 1769-L23 controllers may be used.
•
Compact I/O end cap: 1769-ECR (included with your controller).
•
Compact I/O DeviceNet scanner module: 1769-SDN (only if you are using a
DeviceNet network).
•
Network cable: Ethernet (1585J-M8 or similar), serial (1756-CP3).
•
Stratix 6000 or other Ethernet switch.