Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 42)

42 Publication IASIMP-QS010B-EN-P - October 2009
Chapter 2 Prepare the Computer, Network, and Controller
Assign an IP Address to the Packaged Controller
1769-L23E packaged controllers
In this chapter, you use the BOOTP/DHCP server to assign an IP address to the packaged
controller. You use the BOOTP server that you installed with RSLogix 5000 software.
TIP
Devices on the EtherNet/IP network broadcast requests for IP addresses until the IP addresses have been
assigned.
The procedure in this chapter uses the BOOTP server packaged with RSLogix 5000 programming software
to assign IP addresses, however, any industry-standard BootP server can be used.
1. After you have installed and connected your packaged, launch the BOOTP/DHCP
Server utility.
2. From the Tools menu, choose Network
Settings.
3. Enter the Subnet Mask from the
Network Worksheet .
4. Click OK.