Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 72)

72 Publication IASIMP-QS010B-EN-P - October 2009
Chapter 4 Add POINT I/O
The Request History displays
all the devices, including the
packaged controller, on your
network that need an IP
address. The Ethernet address
(MAC ID) of the adapter
corresponds with the address
you recorded on
Network Worksheet .
5. Double-click the request
from your adapter.
6. Enter the IP address and
record it on the
Network Worksheet inside
the back cover.
If you are not using an isolated
network, obtain these numbers
from your network
administrator.
7. Click OK.
8. To disable BootP/DHCP, select the adapter from the Relation List and click Disable
BOOTP/DHCP.
[Disable BOOTP/DHCP] Command successful
appears in the Status bar.
9. Close the BOOTP/DHCP Server utility.
If you are prompted to save changes, click No.
IMPORTANT
For a device to retain its IP address through a power cycle, BootP/DHCP must be disabled. Complete step
8 to disable BootP/DHCP for the adapter.
IP Addresses Assigned Successfully