Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 71)

Publication IASIMP-QS010B-EN-P - October 2009 71
Add POINT I/O Chapter 4
Assign an IP Address to the POINT I/O Adapter
EtherNet/IP network
In this chapter, you use the BOOTP/DHCP server to assign an IP address to the POINT
I/O adapter. You use the BootP server that was installed with RSLogix 5000 programming
software.
TIP
Devices on the EtherNet/IP network broadcast requests for IP addresses until the IP addresses have been
assigned.
The procedure in this chapter uses the BOOTP server packaged with RSLogix 5000 software to assign
IP addresses, however, any industry-standard BootP server can be used.
1. After you have installed and connected your adapter, launch the BOOTP/DHCP
Server utility.
2. From the Tools menu, choose Network
Settings.
3. Enter the Subnet Mask from the
Network Worksheet .
4. Click OK.