Add point i/o modules to the project, Add point i/o, Modules to the project – Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual User Manual
Page 73: Modules to the, Project
Advertising
Publication IASIMP-QS010B-EN-P - October 2009
73
Add POINT I/O Chapter 4
Add POINT I/O Modules to the Project
3. Select the 1734-AENT
POINT I/O network adap
and click OK.
1. Verify that your project is
Offline.
2. Right-click the network port
and choose New Module.
4. Specify the major revision
and click OK.
Module Properties dialog
box opens.
Advertising