Add a panelview plus 600 terminal, Before you begin, What you need – Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual User Manual
Page 97: Chapter 6, Add a panelview plus, 600 terminal, Before you begin what you need
97
Publication IASIMP-QS010B-EN-P - October 2009
97
Chapter
6
Add a PanelView Plus 600 Terminal
In this chapter, you mount and wire power to a PanelView Plus terminal, configure network
communication, and make network connections. You also use RSView software to create
indicators to represent the push button and output you created in
. You transfer the
application to the PanelView Plus terminal so you can test communication with the
controller.
Before You Begin
•
Create a project in RSLogix 5000 programming software, see
•
Install and configure your network, see
What You Need
•
FactoryTalk View Studio Machine Edition software.
•
PanelView Plus terminal - this quick start uses a PanelView Plus 600 terminal.
•
One power supply, if you are using a PanelView Plus powered by DC power. We
recommend either a 1794-PS3 or a 2711P-RSACDIN, but any DC power supply can be
used.
•
Ethernet cable and switch.
•
For a serial connection, 2706-NC13 cable.