Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 89)

Publication IASIMP-QS010B-EN-P - October 2009 89
Add a PowerFlex 40 Drive Chapter 5
The Request History displays
all the devices, including the
drive, on your network that
need an IP address. The
Ethernet address (MAC ID) of
the drive corresponds with the
address you recorded on
Network Worksheet .
5. Double-click the request
from your adapter.
6. Enter the IP address and
record it on the
Network Worksheet
inside the back cover.
If you are not using an isolated
network, obtain these numbers
from your network
administrator.
7. Click OK.
8. To disable BootP/DHCP, select the drive from the Relation List and click Disable
BOOTP/DHCP.
[Disable BOOTP/DHCP] Command successful
appears in the Status bar.
9. Close the BOOTP/DHCP Server utility.
If you are prompted to save changes, click No.
IMPORTANT
For a device to retain its IP address through a power cycle, BootP/DHCP must be disabled. Complete step
8 to disable BootP/DHCP for the drive.
IP Addresses Assigned Successfully