Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 203)

Publication IASIMP-QS010B-EN-P - October 2009 203
Embedded I/O Chapter 3
Configure the Analog I/O
The analog I/O Module Properties dialog box lets you specify the analog
inputs and outputs you want to enable in your application.
Configuration of the analog I/O is typically completed by using RSLogix 5000
software during the initial system configuration.
To configure your analog I/O in RSLogix 5000 programming software,
complete these steps.
1. In the I/O Configuration tree, right-click slot 3, Embedded IF4XOF2
Analog I/O and choose Properties.
2. Click the Input Configuration tab.