Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 65)

65 Publication IASIMP-QS010B-EN-P - October 2009 65
Chapter
4
Add POINT I/O
In this chapter, you install the 1734 POINT I/O network adapter and the 1734 POINT I/O
modules. You then add POINT I/O modules to your project using RSLogix 5000
programming software. You also add ladder logic and download the project to the controller
so you can test communication with an I/O module. This project builds upon the program
created in
Chapter 3 .
Before You Begin
•
Create a project in RSLogix 5000 programming software, see Chapter 3 .
• Select the appropriate mounting base for I/O modules:
– if you use a 1734-IT2I module, then use the 1734-TBCJC.
– for all other I/O modules, use the 1734-TB or 1734-TBS.
What You Need
• POINT I/O adapter: 1734-AENT for Ethernet./IP network.
•
POINT I/O mounting bases: 1734-TB or 1734-TBS, and 1734-TBCJC.
• A digital-output POINT I/O module. The examples use a 1734-OB4E.
• Power supply: 1794-PS3 or 1794-PS13.
• This chapter also uses the 1734-IB4 module as an example, however, use of the module
is not required.