Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 178)

178 Publication IASIMP-QS010B-EN-P - October 2009
Chapter 2 Network Communication
Step 2: Set Broadcast - Create Controller Scope Message Tag
Next, create a Message tag by following these steps.
1. In the Controller Organizer, right-click the Controller Tags folder and
choose New Tag.
.
The new tag must be a ‘message’ tag.
Error Detection BCC BCC BCC
Duplicate Detection Enabled Enabled N/A
Enable Store and Forward N/A N/A Choose enable if you want to use
the store and forward tag.
The last bit of the INT[16] Enable
Store and Forward array must be
’enabled.’ For example, say you
create an INT[16] tag named
EnableSandF. Then
EnableSandF[15].15 must be set to
1 for broadcast to work on radio
modem.
System Protocol
Field DF-1 Master Protocol DF-1 Slave Protocol DF-1 Radio Modem Protocol