Mount the panelview plus terminal, Wire the panelview plus terminal for power, Mount the – Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual User Manual
Page 99: Panelview plus, Terminal, Wire the panelview, Plus terminal for, Power
Publication IASIMP-QS010B-EN-P - October 2009
99
Add a PanelView Plus 600 Terminal Chapter 6
Mount the PanelView Plus Terminal
2711P-K10C4D1 terminal and all packaged controllers
For the purpose of this quick start, the PanelView Plus terminal can be propped on a desktop.
For further mounting instructions, see the PanelView Plus Terminals User Manual,
publication
Wire the PanelView Plus Terminal for Power
For additional information about wiring power for the PanelView Plus 600 terminal, see the PanelView Plus
400 and 600 Terminals Installation Instructions, publication
.
WARNING
Verify that all incoming power is turned off before wiring power.
1. Remove the wiring terminal
block using a flat-blade
screwdriver to gently pry the
terminal block from the slot.
2. Connect power wires as shown
in the diagram.
3. Insert the wiring terminal
block and press it into place.
AC Power Wiring
L1
L2/N
Protective Earth Ground