Magnetic variation – BendixKing KLN 89B - Pilots Guide User Manual

Page 157

Advertising
background image

4.9.2.

THE OTHER 12 (OTH 12) PAGE

Without a fuel management system this
becomes the OTH 8 page. The follow-
ing information is displayed (figure
4-141):

SAT Static air temperature (the actual temperature of the

surrounding air mass).

TAT Total air temperature (the air temperature including heat rise

due to compressibility. This is the temperature measured
directly by the outside air temperature (OAT) probe.

Prs

Pressure altitude (to nearest 100 feet or 10 meters).

Den Density altitude (to nearest 100 feet 10 meters).

4.10. MAGNETIC VARIATION

The KLN 89(B)'s primary coverage area is from N 74° to S 60° as was
shown in figure 3-1. Magnetic variation is automatically computed within
this coverage area when Mag Var is in the default AUTO mode on the
SET 2 page. Navigation outside this area is automatically referenced to
true North unless a manual input of magnetic variation is made on the
SET 2 page. The following message will be displayed on the Message
page:

*Magnetic Var Invalid

Nav Data Referenced
To True North

A user-defined magnetic variation may be entered on line 4 of the SET 2
page. When a user-entered magnetic variation of 0 degrees is being
used, the following message will be displayed on the Message page:

*Nav Data Referenced

To True North

When a user-defined magnetic variation other than 0 degrees is being
used, the following message will be displayed:

*Nav Data Referenced To

User-Defined Mag Var

There are two exceptions when a user-defined magnetic variation will not
be used for navigation. When the active waypoint is part of an approach

Advanced GPS Operation

4-46

Advanced GPS Operation

Chapter 4

APT VOR NDB INT USR ACT NAV FPL CAL SET OTH

åå.ånm|SAT 5°C
ееееее|TAT 8°C

Leg|Prs 8700ft
OTH 12|Den 9500ft

Figure 4-141

Advertising
This manual is related to the following products: