BendixKing KLN 89B - Pilots Guide User Manual

Page 158

Advertising
background image

KLN 89/KLN 89B Pilot’s Guide

Advanced GPS Operation

4-47

Advanced GPS Operation

Chapter 4

procedure, the magnetic variation for the published approach will be
used and the follwing message will be displayed:

*Mag Var for Published

Approach Being Used

Also, when the unit is in the OBS mode and the active waypoint is a
VOR, the magnetic variation associated with the VOR station willl be
used and the following message will be displayed:

*Mag Var for Published

VOR Being Used

NOTE: A user-entered magnetic variation will not be retained if power is
off for more than 5 minutes. Use of automatically computed magnetic
variation will be restored if power is off for more than 5 minutes and the
unit is within the primary coverage area.

To enter the local magnetic variation manually on the SET 2 page:

1.

Turn on the cursor (

B

).

2.

Move the cursor over the numerical
field on line 4 (figure 4-142).

3.

Press the

E

button to toggle the

magnetic variation cycles field from
automatic to manual if required.
(ORS 02 only) (figure 4-143)

4.

Use the right knobs to select the
magnetic variation, from 0 to 99
degrees.

5.

Move the flashing part of the cursor to the E/W (east/west) field and
select whether the magnetic variation is easterly or westerly (figure
4-143).

6.

Press

F

to approve and turn the cursor (

B

) off.

NOTE: The above format for the SET 2 page applies to ORS 02 soft-
ware. ORS 01 software only allows the selection of a user-entered
magnetic variation when the unit is outside of the primary coverage area,
while ORS 02 software always allows the user to specify the magnetic
variation.

APT VOR NDB INT USR ACT NAV FPL CAL SET OTH

åå.ånm|DATE«25 DEC 02
ееееее|TIME 1830:09 EST
Leg| Eastern Std
SET 2 |Mag Var: >Auto

Figure 4-142

APT VOR NDB INT USR ACT NAV FPL CAL SET OTH

åå.ånm|DATE 25 DEC 02
ееееее|TIME 1830:09 EST
Leg| Eastern Std
*CRSR*|Mag Var: 10°E

Figure 4-143

Advertising
This manual is related to the following products: