Basic gps operation 3-46 – BendixKing KLN 89B - Pilots Guide User Manual
Page 83

Basic GPS Operation
3-46
Basic GPS Operation
Chapter 3
PRIVATE if it is a private use airport.
If the airport is being viewed as part of
the nearest airports list (see section
3.8.1, “Viewing the Nearest
Waypoints”), the APT 1 page format
will differ as follows (see figure
3-138):
Line 1: After the airport identifier, the number designating the air-
port’s position in the nearest airport list is displayed. In figure 3-138,
KLIT is the third nearest airport.
Line 2: Same as a normal APT 1 page.
Line 3: The length, surface and lighting of the longest runway.
Line 4: The magnetic bearing to or the magnetic radial from the
airport and the distance. Placing the cursor over the radial/bearing
field and pressing
E
toggles between radial from and bearing to the
airport.
3.11.1.2. The Airport 2 (APT 2)
Page
See figure 3-139.
Line 1: The ICAO identifier (see
section 2.3) of the airport; an arrow
precedes the identifier if it is the active waypoint.
Lines 2-3: The latitude and longitude of the airport reference point
(the “official” location of the airport).
Line 4: The magnetic bearing to or the magnetic radial from the air-
port and the distance. Placing the cursor over the radial/bearing field
and pressing
E
toggles between
radial from and bearing to the airport.
If the airport is being viewed as part of
the nearest airports list (see section
3.8.1, the APT 2 page format will
differ as follows (see figure 3-140):
Line 1: After the airport identifier, the number designating the air-
port’s position in the nearest airport list is displayed.
Line 2: The city where the airport is located.
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KLIT 3 260ft
ееееее|ADAMS
Leg| 7200ft HRD L
APT 1 |>103°To 14.5nm
Figure 3-138
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KLIT
ееееее| N 34°43.74'
Leg| W 92°13.47'
APT 2 |>103°To 14.5nm
Figure 3-139
APT VOR NDB INT USR ACT NAV FPL CAL SET OTH
åå.ånm| KLIT 3
ееееее|LITTLE ROCK
Leg|AR
APT 2 |>103°To 14.5nm
Figure 3-140