Example of a sid procedure – BendixKing KLN 89B - Pilots Guide User Manual

Page 193

Advertising
background image

3.

With the cursor over the procedure header, press

F

to change

the SID or STAR or press

E

and then

F

to delete the entire

procedure.

NOTE: Any waypoints manually added to a SID or STAR will be
deleted if the SID or STAR is changed or deleted using the above
procedure.

5.2.4. EXAMPLE OF A SID PROCEDURE

To illustrate the use of the KLN 89B with a SID, the Porte Nine
departure loaded into the flight plan in section 5.2.1 will be used.
Remember that “RW01B” was selected meaning that the procedure
is applicable to both runways 1L and 1R. The Fellows (FLW)
transition was also selected. This procedure is one of the more
difficult that you are likely to come across. Most procedures are not
this difficult, but this SID serves as a good example for what steps to
take when you encounter a difficult procedure.

To fly this procedure use the following steps and refer to the chart for
this SID (figure 5-43):

1.

Load the SID as described in section 5.2.1.

2.

The procedure states “Intercept and proceed via SFO R-350,
cross the 4 DME fix at or above 1600’...”. To accomplish this por-
tion of the SID, put the KLN 89B into the OBS mode with SFO04
as the active waypoint and make 350° the selected course. It is
easiest to accomplish these steps before take-off. SFO04 is the
waypoint that is 4 DME from the SFO VORTAC and 350° is the
inbound course to this fix. After take-off climb to 1600’ as
required by the SID.

3.

Once the aircraft reaches SFO04, turn left to a heading of 200°.
At this point it is necessary to manually change the active way-
point to “PORTE”. This is done easily from either the NAV 4 page
or from the FPL 0 page. In either case, once PORTE is
highlighted by the cursor, press

D

to bring up the direct to

page.

4.

Press

F

to confirm PORTE as the direct to waypoint.

5.

Change the selected course on the HSI or CDI to the new value
of 135°. As required by the SID, continue flying a heading of 200°
until the HSI or CDI needle centers and then fly to keep the
needle centered and fly to PORTE.

Approaches and SID/STARs

5-34

Approaches and SID/STARs

Chapter 5

Advertising
This manual is related to the following products: