KEYENCE Visual KV Series - Manual (Page 113)

3.4 Device Mode
Chapter 3 Access Window
1-89
1
3
Visual KV
Series
Changing a numeric value
Change the setting contents of a selected device.
■ Operating procedure
Initially select the device No. to be changed.
1. Select the numeric value change status.
When the key is pressed and held for 3 seconds, a digit to be changed begins
flashing.
In this example, the 5th digit is flashing. When the device No. to be changed
consists of two lines, the 5th digit in the lower line flashes.
2. Select a digit to be changed.
When the key is pressed, a flashing digit is changed.
Change order of digits to be changed
Note: When there are 2 lines, the flashing digit moves among all digits of each line
sequentially. (5th digit of 2nd line
➞ 4th ➞ 3rd ➞ 2nd ➞1st of 2nd line ➞ 5th of 1st
line ➞ 4th ➞ 3rd ➞ 2nd ➞ 1st of 2nd line ➞ 5th of 2nd line....) This continues until
any digit value is changed. After that, the flashing digit moves within the line whose
value has been changed. To change the line, press the key for 3 seconds twice to
enter the change status again.
Digit whose numeric value
can be changed
Press and hold it for 3 seconds.
Digit whose numeric value
can be changed
In case of 1 line In case of 2 lines
Start
Start
3 seconds
3 seconds
KVHKA Chap 03.p65 08.3.11, 11:12 AM 89