KEYENCE Visual KV Series - Manual (Page 203)

5.3 Module/Unit Connections
KV
-300
KV-10/80
1
5
Chapter 5 KV-300 Hardware
1-179
5.3.3 Assembling the System
Connecting modules
To connect the modules, follow the procedure below.
Connection procedure
To connect two modules as shown below:
1. Open the lock levers.
Open the two lock levers (upper and lower, as shown) of the right module (KV-
C32X) by pivoting them open.
2. Connect the modules.
Insert the lock lever of the right module (KV-C32X) into the slot of the left module
(KV-300 CPU). The bus connector of the KV-300 CPU connects to that of the
KV-C32X.
3. Close the lock levers.
Push down on the lock levers of the right module (KV-C32X) as shown until they
sit flush with the surface of the module. No gap should remain between the
modules.
KV-300 KV-C32X
Bus connector
KVHKA Chap 05.p65 08.3.11, 11:14 AM 179