KEYENCE Visual KV Series - Manual (Page 303)

7.6 Display Interface Mode Programming KV-300 Series Only
KV
-300
KV-10/80
Chapter 7 KV-L2 Serial Interface Module
1-279
1
7
Read status of counter/timer/high-speed counter comparator (RG)
This command reads the ON/OFF status of the counter/timer/high-speed counter
comparator starting from the specified no. within the specified range.
■ Command format
■ Response format (When the command is executed normally, the response
includes the end code "00".)
Note 1: The values of the counter/timer and high-speed counter comparator CTC
cannot be read with a same single command at once. Read the counter/timer and
CTC values individually.
Note 2: The station no. is indicated in decimal; the end code, in hexadecimal.
Read DM value (RD)
This command reads values of the data memory addresses starting from the
specified DM address within the specified range.
■ Command format
■ Response format (When the command is executed normally, the response
includes the end code "00".)
Read I/O relay/internal utility relay (RJ)
Reads values of the I/O relays/internal utility relays starting from the specified relay
ch. within the specified range.
Read start No. Data to read
0001 to 0249 Timer/counter
0250 High-speed counter comparator CTC0
0251 High-speed counter comparator CTC1
0252 High-speed counter comparator CTC2
0253 High-speed counter comparator CTC3
0001 to 0250/
0001 to 0004
(in decimal)
Station no.
nn
@ RG FCS ❋ C
R
End code
nn
ON/
OFF
ON/
OFF
Header code Terminator Data of read start no. +1
(ON: 1 OFF: 0) Data of read start no.
(ON: 1 OFF: 0)
@ RD FCS ❋ C
R
Station no.
nn
End code
nn
Data
nnnn Data
nnnn
Header code Terminator Data of read start DM
no.+1 (in hexadecimal) Data of read start DM
no. (in hexadecimal)
Station no.
nn
@ RG FCS ❋ C
R
Read start
no.
nnnn
Number of
counters/timers/
comparators to
read nnnn
Header
code
00 to 15
(in decimal)
Terminator 0000 to 0249/
0250 to 0253
(in decimal)
@ RD FCS ❋ C
R
Station no.
nn
Read start
DM no.
nnnn
Number of DMs
addresses to
read
nnnn
Header
code
00 to 15
(in decimal)
Terminator 0001 to 10000
(in decimal) 0000 to 9999
(in decimal)
KVHKA Chap 07_5to10.p65 08.3.11, 11:18 AM 279