Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 175)

Chapter 6: Using the Command Line Interface (CLI)
SHARK™ IAD User’s Guide XEL P/N & Release 9SA-USRS-9.0R1.02 Chapter 6-59
dst-module (XCON-IF wan1 src-time-slot-5)>> dst-module
(XCON-IF wan1 src-time-slot-5 dst-module)>> set param, where parameter =
•
wan1 - Specifies the module in WAN slot number 1 as the destination for
the specified connection.
•
wan2 – Specifies the module in WAN slot number 2 as the destination for
the connection.
•
lan1 - Specifies the module in LAN slot number 1 as the destination for the
specified connection.
•
lan2 - Specifies the module in LAN slot number 2 as the destination for the
specified connection.
•
t1-1 - Specifies the first T1 in the XC2T module for the specified
connection.
•
t1-2 - Specifies the second T1 in the XC2T module for the specified
connection.
•
router - Specifies the router module as the destination for the specified
connection.
•
vc1 - Specifies the module in voice slot number 1 as the destination for the
specified connection.
•
vc2 – Specifies the module in voice slot number 2 as the destination for the
specified connection.
•
vc3 - Specifies the module in voice slot number 3 as the destination for the
specified connection.
NOTE See "Destination channel restrictions" for router and voice channel restrictions
on page 6-59.
dst-time-slot (XCON-IF wan1 src-time-slot-5 dst-module)>>dst-time-slot
(XCON-IF wan1 src-time-slot-5 dst-time-slot)>>set param, where parameter
=
• 1 – 24 for WAN, LAN and T1 in XC2T modules.
• 1 – 48 for ROUTER module.
• 1 – 8 for VOICE modules.
This command selects the time slot in the terminating module.
Cross connect
configuration
restrictions The following cross connect configuration restrictions must be followed when
specifying the destination channels.
1. Only one group of contiguous channels may be cross connected from each
WAN port to the ROUTER. In addition, XCON-1 connections must use