Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 226)

Chapter 9- Hardware Specifications
Chapter 9-26 XEL P/N & Release: 9SA-USRS-9.0R1.02 SHARK™ IAD User's Guide
standards:
ANSI T1.403-1995 ANSI T1.403-1995
ANSI T1.231-1993 AT&T TR 62411 (12-90)
AT&T TR 54016.
This interface card will also, as part of the IAD, comply with and pass the
applicable required tests specified in the following documents:
FCC Part 68,
CS-03
UL (1950)
Bellcore (GR-1089-CORE, for type 1 units)
EMI Filtering An EMI filter is shipped with every T1 module. Install this filter as shown in
Figure 20. Failure to install these filters as shown may void the FCC licensing
of your SHARK™ IAD unit.
CAT 5 cable transporting
T1 signals. Loop cable
through the filter as shown. T1 connector that
connects to T1 module
9SA-T100-000
XEL part number 180-A2003-01 supplied with module 9SA-T100-000
2"
FCC requirements are that the EMI filter be
installed by the customer approximately 2" from
the end of the T1 input cable as shown.
Figure 20: CAT 5 cable used for T1 transmission EMI filter installation
P
ART
H
ISTORY Part Number Features
9SA-T100-V01 Initial release
9SB-T100-V01 Added the link from the Router to the FDL in ESF
Framing.
9SA-T100-V02 Version for use in the LAN slots only.