Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 5)

Trademarks, Copyrights, License, Tech Support, Safety Preface
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Page: v
Approvals: Certified for UL# 1950 , CSA 22.2 No. 950
Copyright Copyright© 2004 XEL Communications, Inc. All rights reserved. This publication is protected
by federal copyright law. No part of this publication may be copied or distributed, transmitted,
transcribed, stored in a retrieval system, or translated into any human or computer language in
any form or by any means, electronic, mechanical, magnetic, manual or otherwise, or disclosed
to third parties without the express written permission of XEL Communications, 17101 East
Ohio Drive, Aurora, Colorado, 80017, 1-888-468-6935. XEL Communications makes no
representation or warranties with respect to the contents hereof and specifically disclaims any
implied warranties of merchantability or fitness for a particular purpose. Further, XEL
Communications reserves the right to revise this publication and to make changes from time to
time in the contents hereof without obligation of XEL Communications to notify any person of
such revision or changes.
License Subject to the XEL standard terms and conditions of sale or, if applicable, an existing sales
agreement between XEL and XEL’s customers, XEL grants and you accept a perpetual, non-
exclusive license to use any object code software provided by XEL (the Licensed Program) only
with XEL supplied equipment up to the number of cards at your company’s location or at the
locations of users who have acquired XEL equipment through your company as provided in the
upgrade purchase agreement. In no event will the rights to copy, transfer or transmit the Licensed
Program exceed the prescribed quantity limitation in the upgrade purchase agreement. All other
terms of the Software License and Warranty remain in effect.
Safety Information
and Precautions The equipment is designed and manufactured in compliance with Safety Standard UL1950
The following precautions should be observed to ensure personal safety during installation or
service, and prevent damage to the equipment or equipment to be connected.
Read and follow all warning notices and instructions marked on the product or included in this
Reference Guide.
Only qualified technicians should perform these tasks.
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
3. Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
5. Never attempt to remove the power module without first disconnecting input power cables.
6. The external power converter supply for this product must be used with a three-wire
grounding type plug - a plug that has a grounding pin. If DC power is connected directly to
the unit the "Frame GND" pin must be properly grounded. This is a safety feature.
Equipment grounding is vital to ensure safe operation. Do not defeat the purpose of the
grounding type plug by modifying the plug or using an adapter. There is a frame grounding
lug on the rear of the unit.
Prior to installation, use an outlet tester or a voltmeter to check the AC receptacle for the
presence of earth ground. If the receptacle is not properly grounded, the installation must not
continue until a qualified electrician has corrected the problem. If a three-wire grounding
type power source is not available, consult a qualified electrician to determine another
method of grounding the equipment.
7. Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation
of the product and to protect it from overheating, these slots and openings must not be
blocked or covered.