Craft interface connector baud rate switch, Craft interface connector baud rate switch -15, Igure – Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual User Manual
Page 215: Raft, Election switch, Aceplate, Thernet connector, Able, Ate switch settings, Thernet connector pin definitions
Chapter 9- Hardware Specifications
SHARK™ IAD User's Guide XEL P/N & Release: 9SA-USRS-9.0R1.02 Chapter 9-15
sw1 sw2 sw3
I
O
Figure 10:
Craft Port Baud Rate Selection switch
Craft Interface
Connector Baud
Rate Switch
The baud rate is set from the three-position DIP (Figure 10) switch on the
faceplate allowing a choice of 9.6, 19.2, 38.4, 57.6, 64 and 115.2 kbps.
Table 3:
Craft Port Baud Rate switch settings
sw1 sw2 sw3 Baud Rate
0
0
0
9600
0
0
I
19.2k
0
I
0
38.4k
0
I
I
57.6k
I
0
0
64.0k
I
0
I
115.2k
I
I
0
Spare(Do not use)
I
I
I
Spare(Do not use)
10/100BaseT
Connector
Provides: Ethernet Connection to Internal SHARK™ IAD Router and
Management functions.
Front View
4
5
6
8
1
3 2
7
Figure 11:
Faceplate Ethernet connector
Table 4:
Ethernet connector pin definitions
Pin
Signal Name
Pin
Signal Name
1
Transmitted Data +
5
reserved*
2
Transmitted Data –
6
Received Data –
3
Received Data +
7
reserved*
4
Reserved*
8
reserved*
* Under no circumstances make any connection these pins