HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 12)

12
F
unctions Chang
e
d in Sof
tw
a
re
340 49x
-05
Functions Changed in Software
340 49x-05
„ The cyclindrical surface cycles 27, 28, 29 and 39 can now also be
used with modulo rotary axes. In the past, Machine Parameter 810.x
= 0 was required.
„ Cycle 403 does not check whether touch points and compensation
axis match. As a result, probing is also possible in a tilted coordinate
system (see “BASIC ROTATION compensation via rotary axis (Cycle
403, DIN/ISO: G403)” on page 319)