HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 226)

226 Canned Cycles: Cylindrical Surface
8.6 Pr
ogr
amming Examples
8 L C+0 R0 FMAX M3 M99 Pre-position rotary table, spindle ON, call the cycle
9 L Z+250 R0 FMAX Retract the tool
10 PLANE RESET TURN FMAX Tilt back, cancel the PLANE function
11 M2 End of program
12 LBL 1 Contour subprogram, description of the midpoint path
13 L C+40 Z+0 RL Data for the rotary axis are entered in mm (Q17=1)
14 L Z+35
15 L C+60 Z+52.5
16 L Z+70
17 LBL 0
18 END PGM C28 MM