HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 51)

HEIDENHAIN iTNC 530 51
2.2 Pr
ogr
a
m Def
a
ults f
o
r Cy
cles
Entering GLOBAL DEF definitions
U Select the Programming and Editing operating mode.
U Press the Special Functions key.
U Select the functions for program defaults.
U Select GLOBAL DEF functions.
U Select the desired GLOBAL DEF function, e.g. GLOBAL
DEF COMMON
U Enter the required definitions, and confirm each entry
with the ENT key.
Using GLOBAL DEF information
If you have entered the corresponding GLOBAL DEF functions at the
beginning of the program, then you can link to these globally valid
values when defining any canned cycle.
Proceed as follows:
U Select the Programming and Editing operating mode.
U Select the canned cycles.
U Select the desired group of cycles, for example:
drilling cycles.
U Select the desired cycle, e.g. DRILLING.
U The TNC displays the SET STANDARD VALUES soft
key, if there is a global parameter for it.
U Press the SET STANDARD VALUES soft key. The TNC
enters the word PREDEF (predefined) in the cycle
definition. You have now created a link to the
corresponding GLOBAL DEF parameter that you defined
at the beginning of the program.
Danger of collision!
Please note that later changes to the program settings affect
the entire machining program, and can therefore change the
machining procedure significantly.
If you enter a fixed value in a canned cycle, then this value will
not be changed by the GLOBAL DEF functions.