HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 79)

HEIDENHAIN iTNC 530 79
3.6 UNIVER
SAL DRILLING
(Cy
c
le
203, DIN/ISO: G203)
3.6 UNIVERSAL DRILLING
(Cycle 203, DIN/ISO: G203)
Cycle run
1 The TNC positions the tool in the spindle axis to the entered setup
clearance above the workpiece surface at rapid traverse FMAX.
2 The tool drills to the first plunging depth at the programmed feed
rate F.
3 If you have programmed chip breaking, the tool then retracts by
the entered retraction value. If you are working without chip
breaking, the tool retracts at the retraction feed rate to the setup
clearance, remains there—if programmed—for the entered dwell
time, and advances again at FMAX to the setup clearance above the
first PLUNGING DEPTH.
4 The tool then advances with another infeed at the programmed
feed rate. If programmed, the plunging depth is decreased after
each infeed by the decrement.
5 The TNC repeats this process (2 to 4) until the programmed total
hole depth is reached.
6 The tool remains at the hole bottom—if programmed—for the
entered dwell time to cut free, and then retracts to the setup
clearance at the retraction feed rate. If programmed, the tool
moves to the 2nd setup clearance at FMAX.