HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 482)

482 Touch Probe Cycles: Automatic Tool Measurement
1
9
.1 F
undamentals
Display the results of measurement
You can display the results of tool measurement in the additional
status display (in the machine operating modes). The TNC then shows
the program blocks in the left and the measuring results in the right
screen window. The measuring results that exceed the permissible
wear tolerance are marked in the status display with an asterisk “*”;
the results that exceed the permissible breakage tolerance are marked
with the character B.