HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 47)

HEIDENHAIN iTNC 530 47
2.1 W
o
rk
ing with Canned Cy
cles
Calling a cycle with CYCL CALL
The CYCL CALL function calls the most recently defined canned cycle
once. The starting point of the cycle is the position that was
programmed last before the CYCL CALL block.
U To program the cycle call, press the CYCL CALL key.
U Press the CYCL CALL M soft key to enter a cycle call.
U If necessary, enter the miscellaneous function M (for
example M3 to switch the spindle on), or end the
dialog by pressing the END key
Calling a cycle with CYCL CALL PAT
The CYCL CALL PAT function calls the most recently defined canned
cycle at all positions that you defined in a PATTERN DEF pattern
definition (see “Pattern Definition PATTERN DEF” on page 55) or in a
point table (see “Point Tables” on page 63).