HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 38)

38
19.1 Fundamentals ..... 478
Overview ..... 478
Differences between Cycles 31 to 33 and Cycles 481 to 483 ..... 479
Setting the machine parameters ..... 479
Entries in the tool table TOOL.T ..... 481
Display the results of measurement ..... 482
19.2 Calibrating the TT (Cycle 30 or 480, DIN/ISO: G480) ..... 483
Cycle run ..... 483
Please note while programming: ..... 483
Cycle parameters ..... 483
19.3 Calibrating the wireless TT 449 (Cycle 484, DIN/ISO: G484) ..... 484
Fundamentals ..... 484
Cycle run ..... 484
Please note while programming: ..... 484
Cycle parameters ..... 484
19.4 Measuring the tool length (Cycle 31 or 481, DIN/ISO: G481) ..... 485
Cycle run ..... 485
Please note while programming: ..... 486
Cycle parameters ..... 486
19.5 Measuring the tool radius (Cycle 32 or 482, ISO: G482) ..... 487
Cycle run ..... 487
Please note while programming: ..... 487
Cycle parameters ..... 488
19.6 Measuring tool length and radius (Cycle 33 or 483, ISO: G483) ..... 489
Cycle run ..... 489
Please note while programming: ..... 489
Cycle parameters ..... 490
19 Touch Probe Cycles: Automatic Tool Measurement ..... 477