HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 196)

196 Canned Cycles: Contour Pocket
7.
8 SIDE FINISHING (Cy
c
le 24, DIN/ISO: G124)
Cycle parameters
U Direction of rotation ? Clockwise = -1 Q9:
Machining direction:
+1:Counterclockwise
–1:Clockwise
Alternatively PREDEF
U Plunging depth Q10 (incremental): Infeed per cut.
Input range: -99999.9999 to 99999.9999
U Feed rate for plunging Q11: Traversing speed of the
tool during plunging. Input range 0 to 99999.9999,
alternatively FAUTO, FU, FZ.
U Feed rate for roughing Q12: Milling feed rate. Input
range 0 to 99999.9999, alternatively FAUTO, FU, FZ.
U Finishing allowance for side Q14 (incremental):
Enter the allowed material for several finish-milling
operations. If you enter Q14 = 0, the remaining
finishing allowance will be cleared. Input range:
-99999.9999 to 99999.9999
Example: NC blocks
61 CYCLE DEF 24 SIDE FINISHING
Q9=+1 ;DIRECTION
Q10=+5 ;PLUNGING DEPTH
Q11=100 ;FEED RATE FOR PLNGNG
Q12=350 ;FEED RATE FOR ROUGHING
Q14=+0 ;ALLOWANCE FOR SIDE
X
Z
Q11
Q12
Q10