HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 68)

68 Canned Cycles: Drilling
3.1 F
undamentals
3.1 Fundamentals
Overview
The TNC offers 9 cycles for all types of drilling operations:
Cycle Soft key Page
240 CENTERING
With automatic pre-positioning,
2nd set-up clearance, optional entry of
the centering diameter or centering
depth Page 69
200 DRILLING
With automatic pre-positioning, 2nd
setup clearance Page 71
201 REAMING
With automatic pre-positioning, 2nd
setup clearance Page 73
202 BORING
With automatic pre-positioning, 2nd
setup clearance Page 75
203 UNIVERSAL DRILLING
With automatic pre-positioning,
2nd setup clearance, chip breaking,
and decrementing Page 79
204 BACK BORING
With automatic pre-positioning, 2nd
setup clearance Page 83
205 UNIVERSAL PECKING
With automatic pre-positioning,
2nd setup clearance, chip breaking,
and advanced stop distance Page 87
208 BORE MILLING
With automatic pre-positioning, 2nd
setup clearance Page 91
241 SINGLE-FLUTED DEEP-HOLE
DRILLING
With automatic pre-positioning to
deepened starting point, shaft speed
and coolant definition Page 94