HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 331)

HEIDENHAIN iTNC 530 331
15.1 F
undamentals
Characteristics common to all touch probe
cycles for datum setting
Datum point and touch probe axis
From the touch probe axis that you have defined in the measuring
program the TNC determines the working plane for the datum:
417 DATUM IN TS AXIS (2nd soft-key
row) Measuring any position in the touch
probe axis and defining it as datum Page 369
418 DATUM FROM 4 HOLES (2nd
soft-key row) Measuring 4 holes
crosswise and defining the intersection
of the lines between them as datum Page 371
419 DATUM IN ONE AXIS (2nd soft-key
row) Measuring any position in any axis
and defining it as datum Page 375
Cycle Soft key Page
You can also run the Touch Probe Cycles 408 to 419 during
an active rotation (basic rotation or Cycle 10).
Active touch probe axis Datum setting in
Z or W X and Y
Y or V Z and X
X or U Y and Z