HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 454)

454 Touch Probe Cycles: Automatic Kinematics Measurement
1
8
.4 MEA
S
URE KINEMA
TICS (Cy
c
le
451, DIN/ISO: G451; option)
Positioning direction
The positioning direction of the rotary axis to be measured is
determined from the start angle and the end angle that you define in
the cycle. A reference measurement is automatically performed at 0°.
The TNC will issue an error message if the selected start angle, end
angle and number of measuring points result in a measuring position
of 0°.
Specify the start and end angles to ensure that the same position is
not measured twice. As mentioned above, a duplicated point
measurement (e.g. measuring positions +90° und -270°) is not
advisable, however it does not cause an error message.
„ Example: start angle = +90°, end angle = –90°
„ Start angle = +90°
„ End angle = –90°
„ No. of measuring points = 4
„ Angle step resulting from the calculation = (–90 - +90) / (4-1) = –
60°
„ Measuring point 1= +90°
„ Measuring point 2= +30°
„ Measuring point 3= -30°
„ Measuring point 4= –90°
„ Example: start angle = +90°, end angle = +270°
„ Start angle = +90°
„ End angle = +270°
„ No. of measuring points = 4
„ Angle step resulting from the calculation = (270 - 90) / (4-1) = +60°
„ Measuring point 1= +90°
„ Measuring point 2= +150°
„ Measuring point 3= +210°
„ Measuring point 4= +270°