HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 471)

HEIDENHAIN iTNC 530 471
1
8
.5 PRESET COMPENSA
TION (Cy
c
le 452, DIN/ISO: G452, option)
Adjustment of tool changer heads
The goal of this procedure is for the workpiece preset to remain
unchanged after changing rotary axes (head exchange).
In the following example, a fork head is adjusted to the A and C axes.
The A axis is changed, whereas the C axis continues being a part of
the basic configuration.
U Insert the tool changer head that will be used as a reference head.
U Clamp the calibration ball.
U Insert the touch probe.
U Use Cycle 451 to measure the complete kinematics, including the
reference head.
U Set the preset (using Q432 = 2 or 3 in Cycle 451) after measuring
the reference head
Example: Measuring a reference head
1 TOOL CALL “TASTER“ Z
2 TCH PROBE 451 MEASURE KINEMATICS
Q406=1 ;MODE
Q407=12.5 ;SPHERE RADIUS
Q320=0 ;SET-UP CLEARANCE
Q408=0 ;RETR. HEIGHT
Q253=2000 ;F PRE-POSITIONING
Q380=45 ;REFERENCE ANGLE
Q411=-90 ;START ANGLE A AXIS
Q412=+90 ;END ANGLE A AXIS
Q413=45 ;INCID. ANGLE A AXIS
Q414=4 ;MEAS. POINTS A AXIS
Q415=-90 ;START ANGLE B AXIS
Q416=+90 ;END ANGLE B AXIS
Q417=0 ;INCID. ANGLE B AXIS
Q418=2 ;MEAS. POINTS B AXIS
Q419=+90 ;START ANGLE C AXIS
Q420=+270 ;END ANGLE C AXIS
Q421=0 ;INCID. ANGLE C AXIS
Q422=3 ;MEAS. POINTS C AXIS
Q423=4 ;NO. OF MEAS. POINTS
Q431=3 ;PRESET