HEIDENHAIN iTNC 530 (340 49x-05) Cycle programming - Manual (Page 470)

470 Touch Probe Cycles: Automatic Kinematics Measurement
1
8
.5 PRESET COMPENSA
TION (Cy
c
le 452, DIN/ISO: G452, option)
U Start angle A axis Q411 (absolute): Starting angle in
the A axis at which the first measurement is to be
made. Input range: -359.999 to 359.999
U End angle A axis Q412 (absolute): Ending angle in the
A axis at which the last measurement is to be made.
Input range: -359.999 to 359.999
U Angle of incid. A axis Q413: Angle of incidence in
the A axis at which the other rotary axes are to be
measured. Input range: -359.999 to 359.999
U Number meas. points A axis Q414: Number of probe
measurements with which the TNC is to measure the
A axis. If input value = 0, the TNC does not measure
the respective axis. Input range: 0 to 12
U Start angle B axis Q415 (absolute): Starting angle in
the B axis at which the first measurement is to be
made. Input range: -359.999 to 359.999
U End angle B axis Q416 (absolute): Ending angle in the
B axis at which the last measurement is to be made.
Input range: -359.999 to 359.999
U Angle of incid. in B axis Q417: Angle of incidence
in the B axis at which the other rotary axes are to be
measured. Input range: -359.999 to 359.999
U Number meas. points B axis Q418: Number of probe
measurements with which the TNC is to measure the
B axis. If input value = 0, the TNC does not measure
the respective axis. Input range: 0 to 12
U Start angle C axis Q419 (absolute): Starting angle in
the C axis at which the first measurement is to be
made. Input range: -359.999 to 359.999
U End angle C axis Q420 (absolute): Ending angle in the
C axis at which the last measurement is to be made.
Input range: -359.999 to 359.999
U Angle of incid. in C axis Q421: Angle of incidence
in the C axis at which the other rotary axes are to be
measured. Input range: -359.999 to 359.999
U Number meas. points C axis Q422: Number of probe
measurements with which the TNC is to measure the
C axis. If input value = 0, the TNC does not measure
the respective axis. Input range: 0 to 12
U No. of measuring points (4/3) Q423: Specify
whether the TNC should measure the calibration ball
in the plane with 4 or 3 probing points. 3 probing
points increase the measuring speed:
4: Use 4 measuring points (standard setting)
3: Use 3 measuring points