Sqrt, Sqrt -16 – RIGOL MSO/DS1000Z Series User Manual

Page 130

Advertising

RIGOL

Chapter 6 MATH and Measurement

6-16

MSO1000Z/DS1000Z User’s Guide

―

Press Auto Scale to enable or disable the auto scale function. When auto

scale is enabled, the instrument will adjust the vertical scale of the

operation results to the optimal value according to the current

configuration.

―

Press fx Operator, fx A and fx B to set the operator and signal sources of

the inner layer operation of Fx operation (please refer to the introduction in

"Fx Operation").

Note:

Sens. is grayed out and disabled. It is only available when a digital

channel is selected as source.

 You can also use HORIZONTAL POSITION and HORIZONTAL

SCALE to adjust the horizontal position and scale of the operation results.

Tip

Because the differential operation is very sensitive to noise, you can set the

"Acquisition Mode" to "Average".

Sqrt

Calculate the square root of the selected source point by point and display the results.

When the operation is invalid, "NAN" is displayed at the bottom of the screen.

Press MATH  Math  Operator to select "Sqrt":
 Press Operation to enable or disable the "Sqrt" operation function.
 Press Source to select the desired channel (CH1, CH2, CH3, CH4 or fx (please

refer to the introduction in "

Fx Operation")).

 Press Offset and use

to adjust the vertical position of the operation results.

 Press Scale and use

to adjust the vertical scale of the operation results.

 Press Scale Reset to adjust the vertical scale of the operation results to the

optimal value according to the current configuration.

 Press Options to set the start and end points of the operation results, enable or

disable waveform invert, etc.
―

Press Start and use

to set the start point of the operation results.

―

Press End and use

to set the end point of the operation results.

―

Press Invert to enable or disable the inverted display function of the

waveform.

―