RIGOL MSO/DS1000Z Series - Manual (Page 39)

Chapter 1 Quick Start RIGOL
MSO1000Z/DS1000Z User’s Guide 1-13
Logic Analyzer
Press this key to open the logic analyzer control menu. You can turn
on or off any channel or channel group, modify the display size of the
digital channel, modify the logic threshold of the digital channel as
well as group the 16 digital channels. You can also set a label for
each digital channel.
Note:
―
This function is only applicable to mixed signal digital oscilloscopes with digital
channels.
― Press LA  D7-D0; when "On" is selected, CH4 function is automatically
disabled; when "Off" is selected, CH4 function recovers automatically. Press LA
 D15-D8; when "On" is selected, CH3 function is automatically disabled;
when "Off" is selected, CH3 function recovers automatically.
Signal Source
Press this key to enter the source setting interface. You can enable or
disable the output of the [Source1] or [Source2] connector at the
rear panel, set the output signal waveform and parameters, turn on
or off the state display of the current signal.
Note: This function is only applicable to digital oscilloscopes with source channels.