RIGOL MSO/DS1000Z Series - Manual (Page 38)

RIGOL Chapter 1 Quick Start
1-12 MSO1000Z/DS1000Z User’s Guide
Front Panel Function Overview
VERTICAL
CH1, CH2, CH3, CH4: analog channel
setting keys. The 4 channels are marked by
different colors which are also used to mark
both the corresponding waveforms on the
screen and the channel input connectors. Press
any key to open the corresponding channel
menu and press again to turn off the channel.
MATH: press MATH  Math to open the
math operation menu under which A+B, A-B,
A×B, A/B, FFT, A&&B, A||B, A^B, !A, Intg, Diff,
Sqrt, Lg, Ln, Exp and Abs operations are
provided. You can also press MATH to open
the decoding menu and set the decoding
options.
REF: press this key to enable the reference waveform function to compare the
waveform actually measured with the reference waveform.
VERTICAL POSITION: modify the vertical position of the current channel
waveform. Turn clockwise to increase the position and turn counterclockwise to
decrease. During the modification, the waveform would move up and down and the
position message (e.g. ) at the lower-left corner of the screen would
change accordingly. Press down this knob to quickly reset the vertical position to
zero.
VERTICAL SCALE: modify the vertical scale of the current channel. Turn
clockwise to decrease the scale and turn counterclockwise to increase. During the
modification, the display amplitude of the waveform would enlarge or reduce. The
scale information (e.g.
) at the lower side of the screen would change
accordingly. Press down this knob to quickly switch the vertical scale adjustment
mode between "Coarse" and "Fine".
Tip
How to set the vertical scale and vertical position of each channel?
The 4 channels of MSO1000Z/DS1000Z use the same VERTICAL POSITION
and VERTICAL SCALE knobs. If you want to set the vertical scale and vertical
position of a channel, please press CH1, CH2, CH3 or CH4 at first to select the
desired channel. Then turn the VERTICAL POSITION and VERTICAL
SCALE knobs to set the values.