TA Triumph-Adler DCC 2520 - Manual (Page 183)

7-1
7 Various Settings and Registration
This section contains explanations on making settings and registering information.
• Turning Print Out of Each Report ON/OFF (Print Report setting)...7-2
• Turning the Bulletin Board ON/OFF (Bulletin Board setting)...7-5
• Setting the Number of Rings [Auto Fax Reception] (Number of Rings setting)...7-6
• Making Volume Settings (Volume setting)...7-7
• Setting the Number of Redial Attempts (Number of Redials setting)...7-9
• Setting the Document Size for Scanning from the Document Processor (Scan from DP
setting)...7-10
• Setting the Default Transmission Mode (TX Mode/Default setting)...7-11
• Selecting the Automatic Reception Mode (Receive Mode setting)...7-12
• Turning Reception Date & Time Print Out ON/OFF (RX Date/Time setting)...7-14
• Selecting the Paper Feed Selection Mode (Fax Paper Feeding Tray setting)...7-15
• Turning Manual Paper Feed ON/OFF (MP Tray setting)...7-17
• Turning Duplex Reception ON/OFF (Duplex RX setting)...7-18
• Turning 2 in 1 Reception ON/OFF (2 in 1 RX setting)...7-19
• Turning Remote Diagnosis ON/OFF (Remote Diagnosis setting)...7-20
• Registering the Remote Test ID (Remote Test ID setting)...7-21
• Receiving faxes at the same size or a reduced size (Reception Size setting)...7-22