TA Triumph-Adler DCC 2520 - Manual (Page 75)

Fax Operation (Various Functions)
3-9
Sending Important Documents Before Others (Interrupt Transmission)
Interrupt Transmission lets you send your
documents before others, eliminating the need to
wait until all communications are complete
whenever the fax is currently scheduled for multiple
communications (Broadcast Transmission or
Polling Reception, etc.), or there are other
communications already scheduled in memory
ahead of yours.
NOTE: Interrupt Transmission may only be accomplished to a single destination.
A maximum of 50 communications (including any combination of Interrupt Transmissions,
communications that use the timer and Standby Transmissions) can be scheduled at one time.
Depending on the timing of when you perform the Interrupt Transmission procedure, there are
occasions where your documents may not be send [immediately] after the current communication.
If you want to cancel an Interrupt Transmission, simply remove the set documents.
To cancel an Interrupt Transmission while it is still waiting to start, perform the same procedure as
in Canceling a waiting transmission in the Direct Feed Transmission mode... on page 3-6.
If you want to cancel the procedure part way through, press the Reset key. The touch panel will
return to the initial mode settings.
1 Press the [Memory TX] key until it
changes to [Dir. Feed Tx].
2 Set the documents you want to transmit in the
Document Processor or on the platen.
NOTE: When the documents are set on the platen, it
is necessary, after each page is scanned, to select
whether or not you want to transmit more pages and
to select the size of each page. (Refer to page 2-8.)
3 Enter the destination fax number.
NOTE: You can enter the fax number using the numeric keys, abbreviated numbers, one-touch
keys or the directory. Chain dial keys can be used as well.
riginal & assign destination.
. 0% for fax transmission.
Application
Abbrev.
Register
Re-dial
On-hook
Dest.
check
Memory TX
Auto RX
Print Report
Memory usage:
OCT-11-2005 16:00
TX
setting